Double sided design allows relocation and lower placement of Panhard bar without removing the bracket.
Steel mount is drilled for LH or RH installation and allows low placement of Panhard bar.
Plated steel front engine mounts weigh 2.3 lbs. and are sold in pairs.
Hub's rotor mount flange is part of the hub, eliminating the need for a separate rotor hat. HN hubs have a 8x7" rotor bolt circle and include 5/8" coarse thread studs, wheel bearing kit and drive flange
Clamp-on bracket fits 3" axle tubes and mounts coil-overs. Mounting holes are 5" from center of rear end.
Superior efficiency is delivered by first passing coolant over the top half of the radiator and then the bottom half, allowing the radiator to dissipate more heat than conventional designs.
