All-in-one T-Handle puller threads into axle for easy installation or removal. Tool includes adapters for fine or coarse 3/8" threaded solid axles, and 3/4" coarse threads for gun drilled axles.
The tail shaft bushing is a regular wear item, located inside the transmission tailshaft housing. It should be replaced when replacing a tailshaft seal or when a driveshaft failure has occurred. A worn bushing will cause excessive side-to-side movement of the slip yoke and create a vibration or leak. Bushing and seal fit GM Powerglide, Turbo 350, Saginaw, Muncie, Bert and Brinn transmissions.
This wheel bearing and seal kit is designed to fit most Wide 5 hubs. The complete kit will update one hub. Includes inner and outer wheel bearings, inner and outer racers and a low drag hub seal. Also includes specially formulated (for racing) synthetic wheel bearing grease.
High performance Standard or High Temp. Synthetic wheel bearing grease.
Universal strap keeps torque tube stabilized and centered in case of coupler or tube failure. Belt fits all torque tube and chassis combinations. Available in black only.
Keep transmission explosions contained if internal sprag or drum fails. Ideal for high horsepower race cars with stock firewall/floor pan where a transmission shield isn't practical. Ballastic nylon Transmission Blanket meets SFI 4.1 specifications and is NHRA/IHRA approved. Blanket is 12" x 49" and complete with straps. May be secured to virtually any automatic or manual transmission.
U-bolt kits for 1310 or 1350 series U-joints secure driveshaft to pinion yoke. Sold in pairs with nuts and lock washers.
Internal seal prevents gear lube from leaking into axle tube, keeping oil in the center section where it belongs to help eliminate premature rear end failure. Bellow type seal retains into most 3" axle tubes regardless of wall thickness. Internal seal diameter of .950" works with most 28 and 31 spline axles.
Made from 3/16" flat steel, loop is 9-1/2" tall, 5-1/2" wide with a 16" wide mounting strap that can be cut and welded for each installation.
